Prelude L4-1955cc 2000 (1987)
Fig. 19 Rear caliper adjusting spring installation. 1986-87 Prelude w/fuel injected engine
16.
Install spring compressor, aligning slit in rear caliper guide with tab on spring cover, Fig. 19, then compress spring until it is fully bottomed in
caliper.
17.
Remove rear caliper guide, ensure flared ends of spring cover are below snap ring groove, then install snap ring and remove spring compressor.
18.
Install adjusting nut, spring A and washer in piston and secure assembly with snap ring.
19.
Coat new piston seal and dust boot with silicone grease and install seals in caliper, ensuring that seals are properly seated in caliper grooves.
20.
Coat outside of piston with suitable lubricant, then install piston on adjusting bolt, rotating piston clockwise until fully seated.
