Prelude L4-1958cc SOHC (1988)
17.
Reconnect the coolant temperature sender
18.
Attach the harness to the P/S supply hose near the thermostat housing bracket.
19.
Install and fasten the P/S supply hose bracket on the right and left sides of the rear beam.
20.
Attach the return line to the right side of the rear beam with a new 6 mm clip.
21.
Install the charcoal canister.
22.
Install the air cleaner.
23.
Reconnect the air intake control diaphragm tube and the air intake sensor connector.
24.
Connect and fasten the hot air pipe.
25.
Connect the air intake tube.
26.
Attach the high tension wire and vacuum tube to the air intake tube.
27.
Raise the vehicle.
28.
Tighten the P/S supply hose to 27.5 ft.lb. (3.8 kg-m), the sensor pipe to 9.3 ft.lb. (1.3 kg-m), and return pipe to 9.3 ft.lb. (1.3 kg-m) at the
valve body.
29.
Clean the valve body and spray with leak check powder.
30.
Connect the canister drain tube.
31.
Lower the vehicle.
32.
Top up the radiator with coolant.
Loosen the cooling system air bleeder and squeeze the upper hose gently to remove any air. Then tighten the bleeder when the coolant
comes out in a steady stream.
33.
Top up the P/S reservoir with P/S fluid.
34.
Start the engine and let it run for two seconds.
CAUTION: Running the P/S pump for more than 2 seconds could cause it to seize due to lack of P/S fluid.
35.
Top up the P/S reservoir with P/S fluid and restart engine.
