Prelude L4-1958cc SOHC (1988)
14.
Place a drain pan under the valve body, then remove the P/S supply hose and sensor pipe from the valve body. Allow the lines to drain.
15.
Remove the stabilizer bar bushing bolts.
16.
Remove the three self-locking nuts which connect exhaust pipes A and B.
17.
Unfasten the clamps for the P/S sensor and return pipes located on the back of the rear beam.
18.
Loosen, but do not remove, the return pipe and disconnect the pipe from its hose section.
19.
Remove the rubber mount of exhaust pipe A.
20.
Lower the vehicle.
21.
With a hacksaw or utility knife, cut through the rubber portion of the P/S supply hose, then separate the two halves of the hose.
22.
Remove the upper half of the P/S supply hose.
23.
Remove the 6 mm clip holding the return line (located on the right side of the rear beam).
24.
Raise the vehicle and remove the bottom half of the P/S supply hose.
25.
Lower the vehicle.
