Prelude L4-1958cc SOHC (1988)
12.
Lower the vehicle.
13.
Disconnect the upper radiator hose, pass the P/S supply hose below the radiator hose, then reconnect the radiator hose and band.
14.
Connect the P/S supply hose to the P/S pump.
Be careful not to damage the O-ring. Bolts should be hand-snugged before being fully tightened.
15.
Install the P/S supply hose bracket A to the cylinder block. Fit the clamp around the supply hose and then install it onto the bracket (make
sure the clamp is facing up).
Install bracket B to the thermostat housing. Fit the clamp around the supply hose and then install it onto the bracket (make sure the clamp is
facing toward the front of the engine compartment).
16.
Fasten the ground wires to the thermostat housing.