Prelude L4-1958cc SOHC (1988)
Rear Toe
21.
Check the rear toe settings.
Right rear toe-in: 1 - 2 mm Left rear toe-in: 1 - 2 mm Total rear toe-in: 3 +/- 1 mm
NOTE:
The toe for each wheel should be the same.
If adjustment is required, go to step 22. If adjustment is not required, go to step 24.
22.
Loosen the tie-rod locknut and turn the tie-rod shaft until the toe setting is correct.
NOTE:
One full turn of the tie-rod shaft changes the toe approximately 8.7 mm (11/32 in.).
23.
After adjustment, tighten the tie-rod shaft locknut and reposition the tie-rod boot if necessary.
Front Toe
24.
Check the front toe settings.
Right front toe:
0 +/- 1 mm
Left front toe:
0 +/- 1 mm
Total front toe:
0 +/- 2 mm
NOTE:
The toe for each wheel should be the same.
If adjustment is required, go to step 25. If adjustment is not required, go to step 27.
25.
Loosen the tie-rod locknut and turn the tie-rod shaft until the toe setting is correct.
NOTE:
One full turn of the tie-rod shaft changes the toe approximately 7.2 mm (9/32 in.).
26.
After adjustment, tighten the tie-rod shaft locknut and reposition the tie-rod boot if necessary,
27.
Recheck the final toe settings.