Prelude L4-1958cc SOHC (1988)
12.
Disconnect drain hose from steering gear.
13.
Remove tie rod end from left hand tie rod.
14.
Slide steering gear out through right hand side of vehicle.
15.
Reverse procedure to install.
Fig. 7 Rear steering unit attaching bolts. 1988 Prelude 4 wheel steering
Rear Unit
1.
Raise and support rear of vehicle, then remove rear wheel and tire assemblies.
2.
Using a suitable tool, disconnect tie rod ends from steering knuckles.
3.
Slide steering guard joint forward, then remove steering yoke bolt.
4.
Remove steering unit attaching bolts, then remove steering unit, Fig. 7.
5.
Reverse procedure to install.
Except 4 Wheel Steering
Before disassembling the steering gear, clean gear thoroughly to prevent dirt from entering the unit. During disassembly, carefully note and
label disassembled component (part) from the main gear unit to aid in the assemble process.
Control Unit Disassembly
1.
Drain power steering fluid, then remove gear box shield.
2.
Remove pressure lines using suitable wrench.