Prelude L4-2.2L SOHC (1994)
1. 4WS only: Check the rear main steering angle sensor is in the neutral position and jump the service check connector to turn the 4WS indicator ON.
NOTE: Maintain this condition during inspection.
2. Release parking brake.
3. Check the rear toe.
NOTE:
^ Measure difference in toe measurements with the wheels pointed straight ahead.
^ If the parking brake is engaged, you may get an incorrect reading.
Rear toe-in: 2.0 ± 2.0 mm (0.08 ± 0.08 in)
-
If adjustment is required, go to step 4.
-
If no adjustment is required, remove alignment equipment.
4. 2WS:
^ Hold the adjusting bolt on the rear lower arm B and loosen the self-locking nut.
^ Adjust the rear toe by turning the adjusting bolt until toe is correct.
^ Install the new self-locking nut and tighten while holding the adjusting bolt.
4WS: