Prelude L4-22L SOHC (1994) Steering Angle Sensor Location
Steering Angle Sensor: Adjustments
SUB STEERING ANGLE SENSOR ADJUSTMENT
Front sub steering angle sensor
NOTE: Before adjusting the sub steering angle sensor, check that the front main steering angle sensor is adjusted properly.
1. Jack up the car and raise all four wheels off the ground. Place the safety stands in the proper locations to support the car.
2. Set the steering wheel in the straight driving position.
3. Take out the service check connector (BLU 2P) from behind the center console. Connect the terminals with a piece of jumper wire.
NOTE:
^ The 4WS indicator light will not indicate that the sensors are in the electronic neutral position when displaying stored problem codes.
^ Check and verify any problem codes displayed before checking the electronic neutral position.
4. Set the parking brake lever and turn the ignition switch on (engine off). Be sure that the parking brake indicator light turns on.
5. Turn the ignition switch off.
6. Cut the wire tie from the sub steering angle sensor cover, then remove the cover from the sub steering angle sensor.
CAUTION: Use care when cutting the wire tie so as not to cut into the wire harness.
7. Remove the sub steering angle sensor wire harness from the clamp and disconnect the connector.