Prelude L4-2157cc 2.2L DOHC (VTEC) MFI (2001)
Rocker Arm Assembly: Service and Repair
Rocker Arm Installation
CAMSHAFT, ROCKER ARMS AND CAMSHAFT SEAL/PULLEY INSTALLATION
1. Install the lost motion assemblies.
2. Install the rocker arms while passing the rocker arm shaft through the cylinder head.
-
Valve adjusting locknuts should be loosened and adjusting screw backed off before installation.
-
The component parts must be reinstalled in the original locations.
NOTE: Remove the rubber bands after installing the rocker arms.
3. Install the rocker shaft orifices. If the holes in the rocker arm shaft and cylinder head are not in line with each other, thread a 12 mm bolt into the
rocker arm shaft and rotate the shaft.
NOTE:
-
The shapes of the rocker shaft orifices for the intake and exhaust are different. The orifices must be installed in the original locations.
-
Clean the rocker shaft orifices, and install them with new O-rings.