Prelude L4-2157cc 2.2L DOHC (VTEC) MFI (2001)
30. Press the wheel bearing out of the knuckle using a hydraulic press and the special tools shown below.
31. Remove the outboard bearing inner race from the hub using the tools shown.
NOTE: Wash the knuckle and hub thoroughly in high flash point solvent before reassembly.
32. Press a new wheel bearing into the knuckle using the old bearing, a plate, the special tool and a press.
33. Install the circlip securely in the knuckle groove.
34. Install the splash guard and tighten the screws.