Prelude L4-2157cc 2.2L DOHC (VTEC) MFI (2001)
_mfi/Page-1260003.png)
7. Pack the inboard joint with the joint grease included in the new driveshaft set.
-
Grease quantity: 120 - 130 g (4.2 - 4.6 oz).
8. Fit the inboard joint onto the driveshaft.
NOTE: Reinstall the inboard joint onto the driveshaft by aligning the marks on the inboard joint with the marks on the rollers. Hold the driveshaft
so the inboard joint point up to prevent it from falling off.
9. Adjust the length of the driveshafts to the figure, then adjust the boots to halfway between full compression and full extension.
NOTE: The ends of boots seat in the groove of the driveshaft and joint.
