Prelude L4-2157cc 2.2L DOHC (VTEC) MFI (2001)
Shift Fork: Testing and Inspection
Reverse Shift Fork
1. Measure the clearances between the reverse shift fork and 5th/reverse shift piece pin.
-
Standard:
A: 0.05 - 0.35 mm (0.002 - 0.014 inch).
B: 0.4 - 0.8 mm (0.02 - 0.03 inch).
-
Service Limit:
A: 0.5 mm (0.02 inch).
B: 1.0 mm (0.04 inch).
2. If the clearances are more than the service limit, measure the widths of the groove in the reverse shift fork. If the widths of the grooves are not
within the standard, replace the reverse shift fork with a new one. If the widths of the grooves are within the standard, replace the 5th/reverse shift
piece with a new one.
-
Standard:
A: 7.05 - 7.25 mm (0.278 - 0.285 inch).
B: 7.4 - 7.7 mm (0.29 - 0.30 inch).
3. Measure the clearance between the reverse idler gear and reverse shim fork.
-
Standard: 0.5 -1 .1 mm (0.02 - 0.04 inch).
-
Service Limit: 1.8 mm (0.07 inch).