S2000 L4-1997cc 2.0L DOHC (VTEC) MFI (2001)
2. Spraying the top coat enamel
-
Spray the top coat enamel over the surface until the primer surfacer is fully covered.
-
Spray 2-3 coats to get 15-25 microns of thickness.
-
Use the 2-part polyester urethane top coat enamel and spray gun.
-
Mix the top coat enamel with the additive and solvent, using the correct ratio.
-
Follow the top coat manufacturers instructions.
Drying
NOTE: Take care not to let the heat lamp deform the bumper during the drying process.
After spraying top coat enamel, allow for 5-10 minutes of normal drying, then force dry it with infrared lamps or other industrial dryer.
3. Polishing
Check the top coat enamel has dried thoroughly, then sand the top coat enamel.
Use the flexible block and #600-#800-#1000 sand-papers.
NOTE: Be careful not to sand down to the primer surfacer.
When the painting repair is almost complete, polish the top coat.
Use #1500 sandpaper and compound.
4. Air blowing / degreasing
Use alcohol, tack cloth, wax and grease remover.
Clean and degrease surfaces where the masking tape will be attached.
Prepare For Painting
Prepare for Painting