S2000 L4-1997cc 2.0L DOHC (VTEC) MFI (2001)
Seat Belt: Service and Repair
Front Seat Belt
Seat Belt Replacement
SRS components are located in this area. Review the SRS component locations and the precautions and procedures in the SRS section before performing
repairs or service.
NOTE: Check the seat belts for damage, and replace them if necessary. Be careful not to damage them during removal and installation.
Seat Belt
NOTE:
-
Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons.
-
Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work.
1. Remove these items:
-
Seat
-
Rear side trim
-
Spare tire cover and spare tire
-
Rear tray/roll bar and upper trim assembly
2. Remove the seat belt and retractor in numbered sequence.
3. Install the belt in the reverse order of removal, and note these items:
-
Check that the retractor locking mechanism functions.
-
Assemble the washers, collar and busing on the upper and lower anchor bolts. Refer to the Anchor Bolt Construction.
-
Apply liquid thread lock to the anchor bolts before reinstallation.
-
Before installing the anchor bolts, make sure there are no twists or kinks in the seat belt.