S2000 L4-2.2L (2004)
6. Remove the cable clip (A) from the parking brake cable (B).
7. Disconnect the parking brake cable end from the parking brake arm (C).
8. Remove the banjo bolt (A), and disconnect the brake hose (B). Remove the two sealing washers (C), and replace them. Do not spill brake fluid on
the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off immediately with
9. Hold the caliper pin (D) with a wrench, being careful not to damage the pin boot. Remove the two caliper bolts (E) with another wrench, and
remove the caliper (F) from the bracket.
10. Install the rear brake caliper in the reverse order of removal, and note these items:
^
When installing the caliper, align the cutout in the piston with the tab on the inner pad.
^
Check the brake hose and caliper fitting for leaks, and tighten the banjo bolt if necessary.
^
Check the brake hoses for interference and twisting. Contaminated brake discs or pads reduce stopping ability. Keep grease off of the discs and
pads.
Disassembly and Reassembly
Rear Brake Caliper Overhaul