S2000 L4-2.2L (2004)
Parking Brake Cable: Adjustments
Parking Brake Check and Adjustment
Check
1. Pull the parking brake lever (A) with 196 N (20 kgf, 44 lbs.) force to fully apply the parking brake. The parking brake lever should be locked
within the specified clicks (B).
Lever locked clicks: 9 to 13
2. Adjust the parking brake if the lever clicks are out of specification.
Adjustment
NOTE: After rear brake caliper servicing, remove the center console, loosen the parking brake adjusting nut, start the engine, and press the brake
pedal several times to set the self-adjusting brake before adjusting the parking brake.
1. Block the front wheels, then raise the rear of the vehicle, and support it with safety stands in the proper locations.
2. Make sure the parking brake arm (A) on the rear brake caliper contacts the brake caliper pin (B).
3. Pull the parking brake lever up one click.
4. Remove the center console.
5. Tighten the adjusting nut (A) until the parking brakes drag slightly when the rear wheels are turned.
6. Release the parking brake lever fully, and check that the parking brakes do not drag when the rear wheels are turned. Readjust if necessary.
7. Make sure the parking brakes are fully applied when the parking brake lever is pulled up all the way.
