S2000 L4-2.2L (2004)
Air Door Actuator / Motor: Testing and Inspection
Recirculation Control Motor Circuit Troubleshooting
Recirculation Control Motor Circuit Troubleshooting
1. Check the No.20 (7.5 A) fuse in the under-dash fuse/relay box
Is the fuse OK?
YES - Go to step 2
NO - Replace the fuse, and recheck.
2. Disconnect the recirculation control motor 7P connector.
3. Turn the ignition switch ON (II).
4. Measure the voltage between the No.1 terminal of the recirculation control motor 7P connector and body ground.
Is there battery voltage?
YES - Go to step 5
NO - Repair open in the wire between the No.20 fuse in the under-dash fuse/relay box and the recirculation control motor.
5. Turn the ignition switch OFF.
6. Test the recirculation control motor.
Is the recirculation control motor OK?
YES - Go to step 7.
NO - Go to step 11.
7. Disconnect the heater control panel 30P connector.
8. Check for continuity between the No.15 and No.16 terminals of the heater control panel 30P connector and body ground individually.
Is there continuity?