S2000 L4-2.2L (2004)
Ball Joint: Service and Repair
Ball Joint Removal
Ball Joint Removal
Special Tools Required
^
Ball joint thread protector, 14 mm 071AF-S3VA000
^
Ball joint remover, 28 mm 07MAC-SL00200
1. Install the special tool onto the threads of the ball joint (A), by hand until it stops to prevent damage to the threaded end of the ball joint pin.
2. Apply grease to the special tool on the areas shown (A). This will ease installation of the tool and prevent damage to the pressure bolt (B) threads.
3. Loosen the pressure bolt (A), and install the special tools as shown. Insert the jaws carefully, making sure not to damage the ball joint boot. Adjust
the jaw spacing by turning the adjusting bolt.