Accent GL L4-1.6L (2001)
Brake Master Cylinder: Service and Repair
Removal and Installation
REMOVAL
1. Remove the fluid level warning device connector.
2. Disconnect the brake lines from the master cylinder, and plug the open ports.
CAUTION: Do not allow brake fluid to remain on a painted surface. Wash it off immediately.
3. Remove the master cylinder mounting nuts. Disconnect the proportioning valve mounting bracket, then lift out: the master cylinder.
INSTALLATION
1. Install the master cylinder on the brake booster with two nuts.
Nut: 8 - 12 Nm (80 - 120 kg.cm, 6 - 9 ft. lbs.)
2. Connect two brake tubes and fluid level warning connector.
Brake tube flare nut: 13 - 17 Nm (130 - 170 kg.cm, 9 - 12 ft. lbs.)
3. Fill the master cylinder reservoir with brake fluid and bleed the system.