Accent GL L4-1.6L (2001)
16.
The boot program will download first, then the main program and the interrupt vector program.
NOTE:
If the Hi-Scan Pro does not download the program after trying several times, use the Manual Update Procedure following this section.
WARNING:
Do not interrupt the reprogramming at any time. The TCM may be rendered inoperative if the program does not download completely.
17.
When the "REPROGRAMMING COMPLETED!" message is displayed, the TCM reprogramming process is complete.
18.
Turn the ignition to the OFF position for 20 seconds and then start the engine for proper operation.
19.
Check for DTC in the "Engine" and "Automatic Transaxle" menus using the Hi-Scan Pro with SOL cards.
Erase all DTC.
NOTE:
The following erroneous DTC may be set in the ECM after reprogramming. Erase all DTC:
^
P1765: Torque reduction request
^
P1613: MIL request line - High
^
P1693: MIL request line - MAL
MANUAL UPDATE PROCEDURE:
NOTE:
^
In the event that option "01. LC 1.6D AT P/R-D [AUTO MODE]" fails to download the new TCM program, option "02. LC 1.6D AT P/R-D
[ERROR MODE]" must be used.
^
Confirm all connections are established as shown in the "AUTOMATIC UPDATE PROCEDURE" before continuing.
1.
Turn the ignition to the ON position.