Accent GL Sedan L4-1495cc 1.5L SOHC MFI (1997)
Starter Motor: Service and Repair
Disassembly and Reassembly
INSPECTION (AFTER REMOVAL)
PINION GAP ADJUSTMENT
1. Disconnect the wire from the M-terminal.
Fig. 4 Pinion Gap Adjustment (Part 1 Of 3)
2. Connect a 12 V battery between the S-terminal and the M-terminal.
3. Set the switch to "ON", and the pinion will move out.
CAUTION: This test must be performed quickly (in less than 10 seconds) to prevent coil from burning.
4. Check the pinion to stopper clearance (pinion gap) with a feeler gauge. If the pinion gap is out of specification, adjust by adding or removing
washers between the solenoid and the front bracket.
Standard value:
Pinion Gap : 0.5-2.0 mm (0.0197-0.079 in.)
SOLENOID PULL-IN TEST
1. Disconnect the connector from the M-terminal.
2. Connect a 12 V battery between the S-terminal and M-terminal.
CAUTION: This test must be performed quickly (in less than 10 seconds) to prevent the coil from burning.
3. If the pinion moves out, the pull-in coil is good. If it doesn't replace the solenoid.
SOLENOID HOLD-IN TEST