Accent GS Coupe L4-1495cc 1.5L SOHC MFI (1999)
4. Assemble the sliding parts according to the following procedure.
1. Apply rubber grease to the outside surface of the sleeve and pin, pin and sleeve bore of the caliper, pin boot and sleeve boot.
2. Insert the boots into the groove of the caliper.
5. Install the pads.
NOTE: Do not apply grease to the disc or pads.
6. Tighten the brake hose connecting bolt.
Tightening torque:
Sliding pin 34-44 Nm (350-450 kg.cm, 26-33 ft. lbs.)
Sliding bolt 22-31 Nm (220-320 kg. cm, 16-23 ft. lbs.)
Carrier mounting bolt 64-74 Nm (650-750 kg.cm, 4854 ft.lbs.)
Brake hose oil mounting bolt 25-29 Nm (250-300 kg. cm, 18-22 ft. lbs)
NOTE:
1. Check that the surface of the pin and bolts are not damaged before tightening.
2. Bleed the system. Depress the pedal several times and check for fluid leakage from all connecting parts.