Accent GT Coupe L4-1495cc 1.5L DOHC MFI (1997)
4. Measure the backlash between the side gears and pinions.
Standard value: 0.025-0.150 mm (0.001-0.006 inch).
5. If the backlash is out of specification, disassemble and install the correct spacer, reassemble and remeasure.
CAUTION: Adjust the backlash of both side gears to the same specification.
6. Align the pinion shaft lock pin hole with the case lock pin hole and insert the lock pin.
CAUTION:
-
Do not reuse the lock pin.
-
The lock pin head must be sunk below the flange surface of the differential case.
7. Install the ball bearings on both sides of the differential case using special tool (09455-21100) or equivalent.
CAUTION: When press-fitting the bearing, press on the inner race only.
8. Apply specified sealant to the entire threads of the bolts. Tighten to specifications using the illustration.
Specified sealant: BM stud locking No. 2471 or equivalent.