Accent L L4-1495cc 1.5L SOHC MFI (2001)
9.
The Hi-Scan Pro will establish communication and check the ECM ID. The Hi-Scan Pro will reprogram the ECM automatically.
NOTE:
^
The Hi-Scan Pro detects the current ECM ID, assigns the new ECM ID and displays them for a short time.
^
To be prepared in case a reprogramming error occurs, write down the "NEW ECM ID" displayed on the Hi-Scan Pro screen during
reprogramming.
^
It will be used during the Manual Update Procedure if the program does not download correctly.
^
If the Hi-Scan Pro does not download the program, use the Manual Update Procedure following this section.
^
Check the ECM IDs displayed on the Hi-Scan Pro screen to verify that the correct ECM software is being downloaded. Refer to the "ECM
SPECIFICATION TABLE" shown previously in this bulletin for the ECM ID listing.
WARNING:
Do not interrupt the reprogramming at any time. The ECM will be rendered inoperative if the program does not download completely.
10.
When the COMPLETED message is displayed, turn the Hi-Scan Pro OFF and the process is complete.
NOTE:
When reprogramming has been completed successfully, turn the ignition to the OFF position for 20 seconds and then start the engine to check
for proper operation.