Accent L L4-1495cc 1.5L SOHC MFI (2001)
17. With the pinion turned all the way clockwise, tighten the self-locking nut.
18. Apply semi-drying sealant to the threaded section of the end plug and tighten to the specified torque.
Tightening torque: 50 - 70 Nm (500 - 700 kg-cm, 37 - 52 ft. lbs.)
19. Stake the end plug at two points on its circumference with a punch.
20. Install the bushing, rack support, rack support spring and rack support cover in the order shown. Apply semi-drying sealant to the threaded section
of the rack support cover before installation.
21. With the rack placed in the center position, attach the rack support cover to the gear housing. Tighten the rack support cover within the range of 20
- 25 Nm (200 - 250 kg-cm, 14.5 - 18 ft. lbs.), using the Special Tool (09565-21100). Loosen the rack support cover approximately 10°, and
tighten the locking nut to the specified torque.
22. Tighten the feed tube to the specified torque and install the mounting rubber using adhesive.
Tightening torque: 50 - 70 Nm (500 - 700 kg-cm, 37 - 52 ft. lbs.)
23. Apply the specified grease to the bellows mounting position (fitting groove) of the tie rod.
24. Install the attaching band to the bellows.
CAUTION: When the bellows are installed, new bands must be used.