Accent L L4-1495cc 1.5L SOHC MFI (2001)
4. Glue the rubber dam to the inside surface of the rear window glass around the entire edge as shown, to contain the sealant during installation.
5. Install the rear window glass molding without any gaps.
6. Apply a light coat of glass primer to the outside of the dam.
NOTE
1. Never touch the primed surfaces with your hand. If you do, the adhesive may not bond to the glass properly causing a leak after the rear
window glass is installed.
2. Do not apply body primer to the glass.
3. Keep water dust, and abrasive materials away from the primed surface.
7. Apply a light coat of body primer to the original sealant remaining around the window opening flange. The glass should be installed 10 minutes
after you apply the primer.
8. Pack adhesive into the cartridge avoiding air pockets, to ensure continuous application. Put the cartridge in a caulking gun or Sealant Gun, and run
a bead of adhesive around the edge of the glass.
NOTE: Apply the adhesive within 5 minutes after applying the glass primer.
9. Use suction cups or Special Tool, lower the glass over the opening, align it with the marks made in step 3 and set it down on the sealant.
