Accent L Hatch Back L4-1495cc 1.5L SOHC MFI (2000)
6.
Use a bungee cord (or equivalent) to hold open the throttle plate of the throttle body.
7.
Place a shop rag over the end of the surge tank to capture the expansion plug.
8.
Insert a long punch (Snap-On P/N PPB1226 or equivalent) through the bore of the surge tank. Using a hammer, gently tap the expansion plug out
of the opposite end (passenger side) of the surge tank.
CAUTION:
Be careful not to hit the punch into the aluminum Surge Tank. Be sure the punch is directly on the Expansion Plug.
9.
Clean the bore of the surge tank with a shop rag and solvent.
10.
Inspect the PCV installation jig to see if a "punch mark" (indicating "TOP") has already been stamped. The "TOP" punch mark will help orient the
new PCV elbow in later steps. If there is no mark, see Step 11 in KIT # 1 for directions.
