Azera V6-3.3L (2007)
Door Module: Description and Operation
Assist Door Module
ASSIST DOOR MODULE
DESCRIPTION
Assist power window switch, a component of CAN, performs CAN communication with BCM, seat ECU, tilt ECU, driver power window switch.
Passenger controls assist power window switch button located inside of the assist door to operate power window, mirror, door lock and unlock.
1. It performs 4 types of operation of manual up/down and automatic up/down operation for 4 power windows.
2. It performs manual operation of the mirror position by manual switch. (up/down and left/right)
3. It performs registration and replay of mirror position by the mirror switch up to 2 drivers.
FUNCTION
POWER WINDOW CONTROL
1. This switch controls power window up/down, automatic up/down from assist side.
Assist's power window switch sends input signal by the manual up/down and automatic up/down switch input. At the same time manual up/down
and automatic up/down signals sends to the wires.
-> Assist safety window receives the signal and performs manual up/down and automatic up/down functions.
2. Timer function
Power window switch can be controlled for 30 seconds after the ignition is turned off. This function stops immediately even within 30 seconds if
the front door is opened.
OUTSIDE MIRROR CONTROL BY THE SWITCH
1. Manual control of right outside mirror
If the mirror direction switch (up, down, left and right) is pressed when mirror selection switch on driver power window switch is in outside RH
under ACC ON condition, then operating signal is sent to assist power window switch through CAN communication.
OUTSIDE MIRROR MEMORY OPERATION BY THE MEMORY SWITCH
1. It can be memorized assist outside mirror position by CAN communication from driver door module. However, RH side mirror position is not
registered during the LH side mirror manual switch operation.
2. Memory is cleared if the battery is removed.
OUTSIDE MIRROR REPLAY OPERATION BY THE MEMORY SWITCH
1. Mirror is returned to the registered position as each position switch is pressed while the ignition 2 is ON.
2. Memory replay operation will be performed only if the memory is registered.(POS1 or POS2).
3. If the position switch (POS1 or POS2). is pressed while the memory replay is in operation, the final switch is effective.
4. Replay inhibit condition
-
When inhibit "P" switch is OFF
-
When the ignition 2 is OFF
-
When RH side mirror switch is pressed
-
When the vehicle speed is more than 3 km/h
-
When the memory STOP switch is turned ON
OUTSIDE MIRROR MEMORY AND REPLAY OPERATION BY KEYLESS
1. Memory operation
