Elantra L4-1595cc 1.6L DOHC (1993)
Harness Inspection Procedure
Actuator Inspection
Operation Sound Check
1. Check for the sound of the stepper motor after the ignition is switched ON (but without starting the motor).
2. If the operation sound cannot be heard, check the stepper motor's circuit.
3. If the circuit is normal, then the problem may be the stepper motor or the engine control module.
Resistance Measurement between terminals
1. Measure the resistance between the respective terminals.
Standard value
Terminals 2 - 3 or 1: 28 - 33 ohms at 2O° C (68° F)
Terminals 5 - 4 or 6: 28 - 33 ohms at 2O° C (68° F)
Operation check
1. Apply voltage (approx. 6 volts) as follows and check whether or not stepper motor movement occurs.