Elantra L4-1595cc 1.6L DOHC 16 Valve (1995)
Turn Signal Switch
6.
Note the four screws on the cover plate of the Lighting and Turn Signal Switch. Loosen the two inboard screws approximately three turns.
7.
Insert one "C" clip (P/N 14611-03003) underneath each of the two loosened inboard screws. The "C" clips must be placed between the cover plate
and the switch main body.
8.
Tighten the loosened screws. Verify that the lever arm moves freely in both the left and right turn signal switch positions.
9.
Insert the Lighting and Turn Signal Switch assembly into the multifunction switch body and secure with the two screws removed in Step 4.
10.
Install the upper and lower column shrouds and secure with the three screws removed in Step 3.
11.
Connect the negative battery cable and reset the radio stations and digital clock.
12.
Confirm that the non-cancelling concern has been eliminated.
Warranty Information