Elantra L4-2.0L (2004)
Air Bag: Service and Repair
Airbag Handling and Storage
AIRBAG HANDLING AND STORAGE
Do not disassemble the airbags; it has no serviceable parts. Once an airbag has been deployed, it cannot be repaired or reused.
For temporary storage of the air bag during service, please observe the following precautions.
-
Store the removed airbag with the pad surface up.
-
Keep free from any oil, grease, detergent, or water to prevent damage to the airbag assembly.
-
Store the removed airbag on secure, flat surface away from any high heat source (exceeding 200 °F/93 °C)
-
Never perform electrical inspections to the airbags, such as measuring resistance.
-
Do not position yourself in front of the airbag assembly during removal, inspection, or replacement.
-
Refer to the scrapping procedures for disposal of the damaged airbag.
-
Be careful not to bump or impact the SRS unit or the side impact sensors whenever the ignition switch is ON, wait at least three minutes after the
ignition switch is turned OFF before begin work.
-
During installation or replacement, be careful not to bump (by impact wrench, hammer, etc.) the area around the SRS unit and the side impact
sensor. The airbags could accidentally deploy and cause damage or injury.
-
After a collision in which the airbags were deployed, replace the front airbags and the SRS unit. After a collision in which the side airbag was
deployed, replace the side airbag and side impact sensor on the side where the side airbag deployed and the SRS unit. After a collision in which
the airbags or the side air bags did not deploy, inspect for any damage or any deformation on the SRS unit and the side impact sensors. If there is
any damage, replace the SRS unit and/or the side impact sensors.
-
Do not disassemble the SRS unit or the side impact sensors.
-
Turn the ignition switch OFF, disconnect the battery negative cable and wait at least three minutes before beginning installation or replacement of
the SRS unit.
-
Be sure the SRS unit and side impact sensors are installed securely with the mounting bolts.
-
Do not spill water or oil on the SRS unit or the side impact sensors and keep them away from dust.
-
Store the SRS unit and the side impact sensors in a cool (less than 104 °F/40 °C) and dry (less than 80% relative humidity, no moisture) area.