Elantra GLS Sedan L4-2.0L (1999)
Cruise Control Servo Cable: Adjustments
Fig. 2 Actuator Cable Adjustments
ADJUSTMENT CONDITIONS
1. Turn A/C and all lights OFF. Inspect and adjust at no load.
2. Warm engine until stabilized at idle. Confirm idle speed is at specified RPM.
3. Then, ignition switch OFF.
ADJUSTMENT
1. Loosen the adjusting nuts and lock nuts of the accelerator cable and the cruise control cable, so that the throttle lever can move freely.
2. Turn the ignition switch to the ON position (without starting the engine).
3. Tighten the adjusting nut of the cruise control cable in the direction to lessen its play. At the position where the cruise control lever touches the
stopper, unscrew the adjusting nut the specified number of turns.
Amount to unscrew the adjusting nut Approx. 1 turn [inner cable play 1 - 2 mm (0.04 - 0.08 in.)]
4. Lock the cruise cable with the lock nut.
5. While keeping the throttle lever touching the cruise control lever, tighten the adjusting nut of the acceleration cable in the direction to lessen its
play. Then unscrew the adjusting nut the specified number of turns just before the throttle lever begins to move.
6. Lock the accelerator cable with the lock nut.
7. After adjusting, check to see if the end of the fixed idle switch is touching the stopper of the throttle lever.
