Entourage V6-3.8L (2009)
Parking Brake Cable: Adjustments
Adjustment
Adjustment of Rear Brake Shoe Clearance
1. Raise the front of the vehicle, and make sure it is securely supported.
2. Remove the rear wheel and tire from the rear hub.
3. After removing the plug from the disc, rotate the toothed wheel by a screw driver until the disc is not moving, and then return it by 5 notches.
Adjustment Procedure of Disc Foot Parking Brake
1. Adjust the adjusting nut (A) so that parking pedal stoke is to be 88 - 98 mm(3.46 - 3.86 in) when operating effort is 200 N(20 kgf, 44 lb) after full
stroke operation of parking pedal over 3 times for setting parking wire.
CAUTION:
1. The parking brake adjustment must be carried out after adjusting the rear shoe.
2. After adjusting parking brake, notice following matter;
1) Must be free from clearance between adjusting nut and pin.
2) Check securely that the bake is not dragging
Bed-in Procedure for Dih Foot Parking Brake
1. While operating the parking brake pedal for 100 N(10 kgf, 22 lb) effort, drive the vehicle 500 meters (0.31 miles) at the speed of 60 kph (37.3
mph).
2. Repeat the above procedure more than two times.
3. Must be held on at 30% uphill.
CAUTION:
After adjusting parking brake, notice following matter;
1. Must be free from troubles when the parking pedal is operated at 1 kN(100 kgf, 220 lb).
2. Check that all parts move smoothly.
3. The parking brake indicator lamp must be on after the parking pedal is worked and must be off after the pedal is released.
