Entourage V6-3.8L (2009)
1. Raise the vehicle and support it securely.
2. Loosen the rear wheel lug nuts.
3. Remove the rear wheel (A) from the hub (B).
CAUTION:
Take care to not damage the wheel studs when removing the wheel and tire.
NOTE:
When re-installing wheel, use a torque-stick to torque lug nuts to 80 lb4t. Tighten lugs in a star pattern, as shown.
4. Support the lower arm (A) with a jack.
5. Remove the lower arm bolt (B) from the rear knuckle.
NOTE:
Tightening torque: 116-139 lb-ft.
6. Loosen the lower arm bolt (C) from the cross member.
NOTE:
Tightening torque: 145-195 lb-ft.
7. Use caution while slowly lowering the jack until the spring is fully uncompressed.