Genesis Coupe L4-2.0L Turbo (2010)
Brake Rotor/Disc: Testing and Inspection
Front Disc Brake
Front Brake Disc Thickness Check
Inspection
Front Brake Disc Thickness Check
1. Check the brake pads for wear and fade.
2. Check the brake disc for damage and cracks.
3. Remove all rust and contamination from the surface, and measure the disc thickness at 8 points, at least, of same distance (5mm) from the brake
disc outer circle.
Brake disc thickness
General caliper type
Standard: 28mm (1.10in)
Service limit: 26.4mm (1.04in)
Deviation: Less than 0.005mm (0.0002in) - circumference
Less than 0.01mm (0.0004in) - radius
Brembo caliper type
Standard: 28mm (1.10in)
Service limit: 26mm (1.02in)
Deviation: Less than 0.01mm (0.0004in) - circumference
Less than 0.04mm (0.0016in) - radius
4. If wear exceeds the limit, replace the discs and pad assembly left and right of the vehicle.
Front Brake Disc Runout Check
Inspection
Front Brake Disc Runout Check
1. Place a dial gauge about 5mm (0.2 in.) from the outer circumference of the brake disc, and measure the runout of the disc.
Brake disc runout
Limit : 0.035mm (0.00137in.) or less (new one)
2. If the run out of the brake disc exceeds the limit specification, replace the disc, and then measure the run out again.
3. If the run out does not exceed the limit specification, install the brake disc after turning it and then check the run out of the brake disc again.
4. If the run out cannot be corrected by changing the position of the brake disc, replace the brake disc.