hyundai Workshop Repair Guides

Hyundai Workshop Service and Repair Manuals

Engine Controls - MIL ON/DTC P0605/Slow RPM Drop|Page 2678 > < Component Tests and General Diagnostics|Page 2669
Page 1
background image

Engine Control Module: Customer Interest
Engine Controls - MIL ON/DTC P0605/Slow RPM Drop

Group: FUEL SYSTEM

Number: 10-FL-006

Date: MARCH 2010

Model: 2010MY 2.0L GENESIS COUPE (BK)

Subject

ECM UPDATE - DTC P0605 OR SLOW RPM DROP
WHEN RELEASING THROTTLE

This bulletin revises 09-FL-010 to include A/T equipped vehicles.

This bulletin provides information related to an ECM software update of some Genesis Coupe 2.0L vehicles to address either of the following
conditions:

^

Malfunction indicator lamp illuminated with DIG P0605 (Internal Control Module ROM Error) stored in the ECM. Vehicle may have been operating
in the reduced power limp home mode.

^

Slow RPM drop when releasing the throttle during gear shifts or on deceleration from high engine speed

APPLICABLE VEHICLES:

Model: 2010 GENESIS COUPE (BK) 2.0L vehicles.

Affected vehicle production date range: Start of Production - July 10, 2009

NOTE:

To verify the vehicle is affected, check the version of the vehicle's control unit ROM ID with reference to the ROM ID Information Table before
attempting to update the control unit software.

ROM ID INFORMATION TABLE:

^

After the ECM UPDATE, clear any DTC(s) from the control units which communicate with each other by CAN-bus, such as ESC, ACU, TPMS and
the Smart key system. (The ECM is an immobilizer type if the vehicle has the Smart key system.)

SERVICE PROCEDURE:

Engine Controls - MIL ON/DTC P0605/Slow RPM Drop|Page 2678 > < Component Tests and General Diagnostics|Page 2669