Genesis Sedan V6-3.8L (2009)
95440-3C120 as the system and select OK.
3. Enter 3120 as the password for manual upgrade and select OK.
4. If the screen indicates "Voltage is OK", select OK. If not, select CANCEL and run the engine for 5 minutes to charge the battery.
5. The progress bar will indicate when reprogramming reaches 100%. Wait until the next screen indicates reprogramming is complete.
6. Turn the ignition switch OFF for 10 seconds, place it back in the ON position and then select OK. The GDS will confirm that TCM reprogramming is
finished.
7. Reset the TCM adaptive learning values according to TSB 09-AT-002.
8. Check for any Diagnostic Trouble Codes in the ESC menu and erase any DTC present.
9. Start the engine to confirm proper operation of the vehicle.
