Santa Fe L4-2.4L (2001)
1. Remove the clutch hub supporting bolt using the Special Tool.
2. Pull out the clutch hub and shim from the compressor shaft. If it is hard to pull out the hub from compressor, insert an 8 mm bolt into the shaft
hole to remove the hub from the shaft.
3. Remove the pulley supporting the snap ring.
4. Remove the pulley and bearing assembly from the compressor.
ASSEMBLY
1. Clean the pulley bearing surface of the compressor head and remove dirt and rust.
2. Install the pulley and bearing on the compressor.
3. Install the snap ring with its levelled side facing out.
4. Place one space shim of specified size over the hub spline and slide the hub onto the compressor shaft end.
5. Install a new hub supporting bolt at the compressor shaft end. Tighten the bolt with tightening torque.
Tightening torque : 102 - 153 kg.cm
CAUTION: Do not use air tools.
