Santa Fe L4-2.4L (2001)
TROUBLESHOOTING HINTS
The MIL turns ON or the DTC is displayed on the HI-SCAN PRO under the following conditions;
-
When the primary voltage side in PCM is in short or open circuit.
-
The ignition control by the PCM is malfunctioning.
-
Open or short circuit is observed in idle air control system when ignition switch is turned on.
Using Hi-Scan
Harness Inspection Procedure
ACTUATOR INSPECTION
1. Disconnect the connector at the idle speed control actuator.
2. Measure the resistance between terminals.
Standard value
Terminal 3 and 2 : 16.6-18.6 ohm
Terminal 1 and 3 : 14.5-16.5 ohm [at 20 °C (68 °F)]
3. Re-connect the connector to the idle speed control actuator
