Ignition Switch Location for Santa Fe L4-24L (2001) - Page 8711
Ignition Switch: Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect the negative battery terminal.
2. Remove the air bag module.
CAUTION: The SRS system is designed to retain enough power to deploy air bag for about 30 seconds even after the battery has been
disconnected, so serious injury may result from unintended air bag deployment if service is done on the SRS system immediately after the battery
cable is disconnected.
3. Remove the self-tapping screw and lift up horn pad and remove.
4. Remove the lock nut and the washer.
5. Pulling the dynamic damper forward, lift it up and remove it.
6. Install the special tool (09561 - 11001) and remove the steering wheel.
CAUTION: Do not hammer on the steering wheel to remove it.
7. Remove the steering column lower and upper shrouds.
8. Remove the lower cover.
9. Disconnect the connectors and remove the multifunction switch.
