Santa Fe L4-2.4L (2001)
CAUTION: Be careful not to remove more adhesive than necessary, and also not to damage the paintwork on the body surface with the knife. If
the paintwork is damaged, repair the damaged area with touch-up paint.
2. Clean the body bonding surface with a sponge dampened in alcohol, or wax and grease remover.
3. Center the new windshield glass in the opening. Mark the location by marking lines across the glass and body with a grease pencil at the four
points as shown.
4. Glue the rubber dam to the inside surface of the windshield glass around the entire edge as shown, to contain the sealant during installation.
5. Install the windshield glass molding. Do not allow any gaps.