Santa Fe V6-3.5L (2004)
3. If the disc is beyond the limits for thickness or unevenness remove it and install a new one.
FRONT BRAKE DISC RUN-OUT CHECK
1. Remove the caliper support, then raise the caliper assembly upward and suspend with wire.
NOTE: Tighten the nuts in order to mount the disc to the hub.
2. Place a dial gauge about 5 mm (0.2 inch) from the outer circumference of the brake disc, and measure the runout of the disc.
Limit: 0.04 mm (0.0016 inch)
FRONT BRAKE DISC RUN OUT CORRECTION
1. If the run out of the brake disc is equivalent to or exceeds the limit specification, replace the disc and hub, and then measure the run out again.
1) Before removing the brake disc, chalk both sides of the wheel stud on the side at which the run out is greatest.
