Santa Fe V6-3.5L (2004)
ROM INFORMATION TABLE
CAUTIONS DURING REPROGRAMMING:
1.
Make sure the battery has reasonable charge. If the vehicle has been in storage for days run the engine at idle for at least 15 minutes to assure an
adequate battery charge state for reliable reprogramming results.
2.
Perform reprogramming with the ignition key in the ON position.
3.
Turn off all lights (do not leave headlight switch in auto modes.) and all accessories (including heater/air conditioner/blower, radio, heated seats,
rear defroster, etc.) to make certain the battery will not be discharged during reprogramming.
4.
Be careful not to disconnect any cables connected to the vehicle, the GDS or the laptop during reprogramming.
5.
Do not start the engine during reprogramming.
6.
Do not turn the ignition switch OFF during reprogramming.
ECM REPROGRAMMING PROCEDURE:
GDS INSTALLATION PROCEDURE
