Santa Fe V6-3.5L (2004)
5. Using the special tools (09532-32000, 09216-22100), remove the wheel bearing outer race from the knuckle.
INSPECTION
1. Check the hub for cracks and check the splines for wear.
2. Check the hub bolts for cracks and damage.
3. Check the brake disc for scoring and damage.
4. Check the knuckle for cracks.
5. Check the bearings for defects.
REASSEMBLY
1. Apply a thin coat of multipurpose grease to the surface of the knuckle and bearing.
2. Using the special tool, press the bearing onto the knuckle.
Press-in load: 450 - 500 N; 4500 - 5000 kgf (9921 - 11023 lbf)
NOTE:
-
Do not press against the outer race of the wheel bearing because that can cause damage to the bearing assembly.
-
Always use a new bearing assembly.
3. Install the snap ring into the groove of the knuckle.
4. Install the backing plate to the knuckle.
5. Press the hub onto the knuckle using a special tool.
Press-in load: 200 - 250 N; 2000 - 2500 kgf (4409 - 5512 lbf)
NOTE: Do not press against the outer race of the wheel bearing because this can cause damage to the bearing assembly.
6. Rotate the hub several times while seating the bearing.
