Santa Fe V6-3.5L (2004)
1. Remove the suction pipe and the O-ring from the oil pump.
2. Remove the rear cover with its gasket and pin.
3. Remove the cam ring.
4. Remove the rotor and vanes
5. Remove the front side plate.
6. Remove the inner and outer O-ring.
7. Remove the spring.
NOTE: When assembling, use a new gasket and O-ring.
8. Remove the pulley nut and the spring washer.
9. Pull off the pulley and the woodruff key.
10. Remove the snap ring using snap ring pliers.