Santa Fe V6-3.5L (2004)
21. Tighten the feed tube to the specified torque and in stall the mounting rubber with adhesive.
22. Apply the specified grease to the bellows mounting position (fitting groove) of the tie rod.
Recommended grease Multipurpose grease SAE J310a, NLGI #2 EP
23. Install the new attaching band to the bellows.
CAUTION: When the bellows are installed, a new band must be used.
24. Install the bellows in position, taking care not to twist it.
25. Fill the dust cover inner side and lip with the specified multipurpose grease, and place the dust cover in position with the clip ring attached in the
groove of the tie rod end.
Recommended grease Multipurpose grease SAE J310a, NLGI #2 EP
26. Install the tie rods so that the length of the left and right tie rods equals the standard value.
Standard value Tie rod free length: 208.7 mm (8.2 inch)
27. Install the power steering gear box assembly to the vehicle.