Santa Fe V6-3.5L (2004)
5. Fit the selected drive pinion rear shim(s) to the drive pinion, and press-fit the drive pinion rear bearing inner race using the special tool.
ADJUSTMENT OF DRIVE PINION PRELOAD
Adjust the drive pinion turning torque according to the following procedures:
1. Fit the drive pinion front shim(s) between the drive pinion spacer and the drive pinion front bearing inner race.
2. Tighten the companion flange to the specified torque using the special tool.
NOTE: Do not install the oil seal.
3. Measure the drive pinion turning torque. (without the oil seal using the special tool)
STANDARD VALUE
4. If the drive pinion turning torque is not within the range of the standard value, adjust the turning torque by replacing the drive pinion front shim(s)
or the drive pinion spacer.
NOTE: When selecting the drive pinion front shim pack use the minimum number of shims.
