Santa Fe V6-3.5L (2004)
4. Install the Birfield joint into the knuckle.
5. In practice, the knuckle should be installed in the lower arm the moment the Birfield joint is installed in the knuckle. Be careful not to damage the
boot.
6. Install the knuckle in the strut assembly with the tightening torque, 100 - 120 Nm (1000 - 1200 kgf-cm, 74 - 89 ft. lbs.).
7. Install the lower arm in the knuckle with the tightening torque 100 - 120 Nm (1000 - 1200 kgf-cm, 74 - 89 ft. lbs.).
8. After the installation, check on the driveshaft for stability by hand.
9. After installing the washer with convex surface outward, install the castle nut and the split pin.
10. Install the wheel and tire.
Rear Driveshaft (DOJ-BJ Type)
