Santa Fe V6-3.5L (2004)
10. Using suction cups or the special tool (09861-31400), lower the glass over the opening, align it with the marks made in step 3 and set it down on
the sealant.
11. Remove excess adhesive with a putty knife or gauze. Fill any cavities around the windshield glass.
12. After one hour, perform a water-leak test for the windshield. Use a cold water spray, being careful not to direct a powerful stream of water on the
new adhesive material. Allow water to spill over the edges of the glass.
13. If there are leaks, dry the affected area, then apply sealant.
14. Install the removed parts.
CAUTION:
1. Keep the windshield dry for the first hour after installation.
2. Let the car stand for at least four hours after windshield installation. If the car has to be used within the first 8 hours, it must be
driven slowly.
3. Take care not to slam the doors with all the windows rolled up.
4. Take care not to stress the body (such as when going in and out of driveways at an angle or driving over rough, uneven roads).