Santa Fe AWD V6-3.3L (2009)
1. Measure the resistance between the OCV Power and Signal terminals.
2. Check if the OCV operates normally by providing 12V power as shown in the picture above.
IMPORTANT:
Careful attention is necessary to avoid a short circuit when providing the OCV with 12V power. Spacing between the OCV power and signal terminals is
very narrow. Use suitable connections to prevent shorting of the test power supply.
3. When 12V power is provided to the OCV, the OCV must move forward as shown in the picture shown above.
A: Maximum retarded valve timing condition (12V not provided)
B: Maximum advanced valve timing condition (12V provided)
NOTE:
Reverse the connection polarity if the movement is opposite.